FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-139
show
•show.features
• show.security.portbinding
• show.security.switchbinding
• show.security.fabricbinding
•show.openTrunking.config
• show.thresholdAlerts.alerts
• show.fabric.topology
•show.fabric.nodes
• show.security.switchACL
• show.ficonCUPZoning
• show.FencingPolicies
show.auditLog
Syntax auditLog [clear]
Purpose This command displays the entries of the audit log after the last time
the log was cleared.
Parameters This command has one optional parameter.
Command Example
show auditLog
Output The output from this command displays the following data.
clear Adding the optional 'clear' parameter
removes all entries from the log. If the log
is full, it will resume collecting log
entries.
Date/Time The date and time of the log entry.
Action Type of Audit Log event.
Source Source of Audit Log event.
User ID Identifier of the user that made the
command. Usually an IP Address.