FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-141
show
Parameters This command has one optional parameter. If no parameters are
entered, it will show the current state.
Command Example
Root> show epFrameLog filterClassFFrames enable
show.epFrameLog.setFilterPort
Syntax setFilterPort portNumber
Purpose This command sets the port number that the Embedded Port Frame
Log will use for logging. Only frames from the port number that is set
will be added to the log.
Parameters This command has one parameter.
Command Example
Root> show epFrameLog setFilterPort 63
Parameters This command has one optional parameter. If no parameters are
entered, it will show the current state.
Command Example
Root> show epFrameLog setFrameLogPort 63
enable Specifies the on/off state. Valid values are
enable and disable. Boolean 1 and 0 values
may also be substituted.
portNumber This parameter can be set to any port
number (except inaccessible and
unaddressable ports), all, or none.
newPort Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
all - make the FC2 log collect entries from all of
the posts on the switch.
none - make the FC2 log stop collecting entries.