FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-142
Enterprise Operating System Command Line Interface User Manual
show
show.epFrameLog.noWrap
Syntax noWrap [clear]
Purpose This command allows the user to view the contents of the
non-wrapping region of the FC2 frame log. The log entries will not
persist IMLs or power cycles; it will not be stored in NV RAM. This
log will not include entries for frames discarded by hardware, such as
un-routable class-3 frames unless class-3 discard is disabled in the
hardware.
NOTE: This log will not wrap. The log will stop collecting entries after is it
filled.
Parameters This command has one optional parameter. If no parameter is
specified, then the 500 entries of the log will be displayed.
Command Example
show epFrameLog noWrap
Output This command displays the following data.
clear Adding the optional 'clear' parameter
removes all entries from the log.
Count A constantly incrementing counter.
Date/Time Time of the frame.
Port # The port number.
Direction Direction of the frame through the port (I
= In, O = Out).
SOF Start of frame.
EOF End of frame.
Header The 24 byte FC frame header.
PL (size in bytes) The first 32 bytes of the FC frame
payload.