FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-150
Enterprise Operating System Command Line Interface User Manual
show
show.features
Syntax features
Purpose This command displays a table of all installed feature sets and their
states. This command provides the same output as the command
config.features.show on page 2-9.
Parameters This command has no parameters.
Command Example
Root> show features
Output The features data is displayed as a table that includes the following
properties.
Output Example The output from the show.features command displays as follows.
Installed Feature Set Feature State
------------------------------ ----------------- ----
Open Systems Management Server OSMS Enabled
Flex Ports 8 Flex Ports Enabled
SANtegrity Fabric Binding Active
SANtegrity Switch Binding Enabled
SANtegrity Enterprise Fabrics Active
Open Trunking Open Trunking Enabled
show.fencing.policies
Syntax fencing [name]
Purpose This command displays a table of the configured fencing policies. If a
specific policy name is given, then a full description of the policy is
shown.
Installed Feature
Set
The feature set installed using a feature key.
Only installed keys are displayed.
Feature Individual features within each set. In many
cases, there is only one feature within each
feature set.
State The state of the individual feature. Fabric-wide
features are displayed as Active/Inactive.
Switch-centric features are displayed as
Enabled/Disabled.