FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-151
show
Parameters This command has one optional parameter, an individual policy
name. If an individual policy name is given, then a detailed
description will be shown for the specified policy. If no parameter is
given, then a summary of all policies will be shown.
Command Example
Root> show fencing
Root> show fencing Protocol Errors #2
Output The data is displayed as a table that includes the following
properties:
Output Example Root> show fencing
Name Type State
------------------------ --------------- --------
Default_Protocol_Errors Protocol Errors Enabled
Protocol Errors #2 Protocol Errors Disabled
Safety #2 Protocol Errors Enabled
Root> show fencing Protocol Errors #2
Name: Protocol Errors #2
Ports: 2,4-7,20-24
Type: Protocol Errors
Limit: 5
Period: 1800 seconds
State: Disabled
Name The name of the policy. This will be
concatenated to 50 characters in the
summary display. The policy full name
will be shown in comma-delim mode.
Ports The ports to which the fencing policy will
be applied.
Type The type of the fencing policy.
Limit The number of offenses that are allowed
before a port is disabled.
Period The amount of time that limit of number
of offenses must exceed before a port is
fenced.
State The enabled state of the fencing policy.