FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-156
Enterprise Operating System Command Line Interface User Manual
show
more than one device per port for any public loop devices attached to
an FL Port.
Parameters This command has no parameters.
Command Example
Root> show loginServer
Output The device information is displayed as a table that includes the
following properties.
Output Example The output from the show.loginServer command displays as follows.
Port BB Crdt RxFldSz COS Port Name Node Name
---- ------- ------- --- ----------------------- -----------------------
0 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
1 10 2 00:11:22:33:44:55:00:78 20:11:22:33:44:55:66:78
4 10 2,3 00:11:22:33:44:55:00:79 20:11:22:33:44:55:66:79
7 10 2,3 00:11:22:33:44:55:00:80 20:11:22:33:44:55:66:80
8 10 2 00:11:22:33:44:55:00:81 20:11:22:33:44:55:66:81
10 10 2,3 00:11:22:33:44:55:00:82 20:11:22:33:44:55:66:82
11 10 2,3 00:11:22:33:44:55:00:83 20:11:22:33:44:55:66:83
12 10 3 00:11:22:33:44:55:00:84 20:11:22:33:44:55:66:84
13 10 2,3 00:11:22:33:44:55:00:85 20:11:22:33:44:55:66:85
15 10 2,3 00:11:22:33:44:55:00:86 20:11:22:33:44:55:66:86
show.nameServer
Syntax nameServer
Port The port number where the device is attached.
BB Crdt The maximum number of remaining frames
that can be transmitted without causing a buffer
overrun condition at the receiver.
RxFldSz The buffer-to-buffer receive data field size from
the FLOGI received from the attached N_Port.
COS The class of service (for example, 1; 2; 3; 4; 5; 6;
F; 1,2; 2,3).
Port Name The port WWN of the attached device.
Node Name The node WWN of the attached device.