FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-158
Enterprise Operating System Command Line Interface User Manual
show
Output Example The output from the show.nameServer command displays as follows.
Type Port Id Port Name Node Name COS FC4 Types
---- ------- ----------------------- ----------------------- --- ---------
N 010400 00:11:22:33:44:55:66:77 20:11:22:33:44:55:66:77 2,3 2
N 010500 00:11:22:33:44:55:66:78 20:11:22:33:44:55:66:78 2,3 0
N 010600 00:11:22:33:44:55:66:79 20:11:22:33:44:55:66:79 2,3 2
N 010700 00:11:22:33:44:55:66:80 20:11:22:33:44:55:66:80 2 2
N 010800 00:11:22:33:44:55:66:81 20:11:22:33:44:55:66:81 3 2
N 010900 00:11:22:33:44:55:66:82 20:11:22:33:44:55:66:82 3 2
N 010C00 00:11:22:33:44:55:66:83 20:11:22:33:44:55:66:83 2,3 2
N 010D00 00:11:22:33:44:55:66:84 20:11:22:33:44:55:66:84 2,3 2
N 010E00 00:11:22:33:44:55:66:85 20:11:22:33:44:55:66:85 2 5
N 010F00 00:11:22:33:44:55:66:86 20:11:22:33:44:55:66:86 2 4
N 011200 00:11:22:33:44:55:66:87 20:11:22:33:44:55:66:87 2,3 2
N 011300 00:11:22:33:44:55:66:88 10:11:22:33:44:55:66:88 2,3 2
FC4 Types
0: ISO/IEC 8802-2 LLC
1: ISO/IEC 8802-2 LLC/SNAP
2: SCSI-FCP
3: SCSI-GPP
4: IPI-3 Master
5: IPI-3 Slave
6: IPI-3 Peer
7: CP IPI-3 Master
8: CP IPI-3 Slave
9: CP IPI-3 Peer
10: SBCCS-Channel
11: SBCCS-Control Unit
12: FC-SB-2 Channel to Control Unit
13: FC-SB-2 Control Unit to Channel
14: Fibre Channel Service
15: FC-FG
16: FC-SW
17: FC-AL
18: SNMP
19: HIPPI-FP
20: Vendor Unique
show.nameServerExt
Syntax nameServerExt
Purpose This command displays extended information from the name server
database for devices attached to this switch. The command provides
Symbolic Nameserver information, as well as the same information
as the show.nameServer command. Multiple devices per port are
possible for any public loop device attached to an FL Port.
NOTE: Because it contains symbolic nameserver information that can be
lengthy, the CLI output wraps several times per node. For this reason, this
command is supported only in comma-delimited mode. For more
information about the comma-delimited mode, see Using the commaDelim
Command on page 1-17.