FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-159
show
Parameters This command has no parameters.
Command Example
Root> show nameServerExt
Output The device information data is displayed as a table that includes the
following properties.
Output Example The output from the show.nameServerExt command displays as
follows.
Type, Port Id, Port Name, Node Name, COS, FC4 Types, SymNodeName, SymPortName,
N, 010400, 00:11:22:33:44:55:00:77, 20:11:22:33:44:55:66:77, 2-3, 2, Node Name A, Port Name A,
N, 010500, 00:11:22:33:44:55:01:77, 20:11:22:33:44:55:66:77, 2-3, 0, This Is Symbolic Node Name
B, Symbolic Port Name B Is Slightly Longer
N, 010600, 00:11:22:33:44:55:66:02, 20:11:22:33:44:55:66:77, 2-3, 2, , ,
FL, 000001, 00:11:22:33:44:55:66:03, 20:11:22:33:44:55:66:77, 2, 0, Loop Node 1, Loop Port 7
FL, 000002, 00:11:22:33:44:55:66:04 20:11:22:33:44:55:66:77, 3, 2, Loop Node 2, Loop Port 7,
show.NPIV.config
Syntax config
Purpose This command displays the current NPIV configuration for all ports.
Type The type (N, NL, F/NL, F, FL, E, B).
Port Id The 24-bit Fibre Channel address.
Port Name The port WWN of the attached device.
Node Name The node WWN of the attached device.
COS The class of service (for example, 1; 2; 3; 4; 5; 6;
F; 1,2; 2,3).
FC4 Types The FC4 types registered for this device. One or
more numbers display in this field. The
numbers in this field correspond to the list in
the output example for show.nameServer on
page 2-156.
SymNodeName 255-character representation of the Symbolic
Node Name.
SymPortName 255-character representation of the Symbolic
Port Name.