FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-163
show
Output The device information data is displayed as a table that includes the
following properties.
Output Example The output from the show.opentrunking.reroutelog command
displays as follows.
Date/Time RcvPort Dom OldExit NewExit
--------------- ------- --- ------- -------
04/12/01 10:58A 63 2 41 42
03/23/02 12:01P 4 3 35 36
show.port.config
Syntax config
Purpose This command shows the port configuration for all ports.
Parameters This command has no parameters.
Command Example
Root> show port config
Output The port configuration attributes are displayed as a table that
includes the following properties.
Date/Time The date/time when the rerouting event
occurred.
Rcv The port associated with the flow that was
rerouted.
Dom The target domain associated with the flow that
was rerouted.
Old The exit port number on this switch that the
flow used to get to the target domain.
New The exit port number on this switch that the
flow now uses to get to the target domain.
Port The port number.
Name The name of the port as set in the
config.port.name command.
Blocked The blocked state of the port as set in the
config.port.blocked command.