FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-164
Enterprise Operating System Command Line Interface User Manual
show
Output Example The output from the show.port.config command displays as follows.
Port Name Blocked FAN Type Speed Rx Crdts
---- -------------- ------- ------- -------- ----- ---------
0 Port_0_name Blocked Enabled gxPort Negotiate 12
1 Blocked Enabled gxPort Negotiate 12
2 locked Enabled gxPort Negotiate 12
...
show.port.exit
Syntax exit destDomainID sourcePort
Purpose This command displays the exit port from a source port to a given
destination domain. This command shows the Preferred Path
configuration.
Use all for one of the command’s parameters to display all configured
and actual exit ports for either the destination domain ID or the
specified source Port. You cannot specify all for both parameters. If
the destination domain is set to all, then all paths from the specified
source port are displayed. If the source port is set to all, the output
shows all source port paths to the specified domain.
FAN The configured fabric address notification
(FAN) state. (Sphereon 4300 and Sphereon 4500
switches only.)
Type The port type as set in the config.port.type
command.
Speed The port speed as set in the config.port.speed
command.
Rx Crdts The number of Rx BB Credits as set in the
config.port.rxCredits command.