FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-167
show
Output The port information data is displayed as a table that includes the
following properties.
Output Example The output from the show.port.info command displays as follows.
Port WWN OpSpeed SpeedCap
---- ----------------------- -------- --------
0 10:00:80:00:11:22:33:44 1 Gb/sec 2 Gb/sec
1 10:00:80:01:11:22:33:44 1 Gb/sec 2 Gb/sec
2 10:00:80:02:11:22:33:44 1 Gb/sec 2 Gb/sec
3 10:00:80:03:11:22:33:44 1 Gb/sec 2 Gb/sec
4 10:00:80:04:11:22:33:44 2 Gb/sec 2 Gb/sec
5 10:00:80:05:11:22:33:44 2 Gb/sec 2 Gb/sec
6 10:00:80:06:11:22:33:44 2 Gb/sec 2 Gb/sec
7 10:00:80:07:11:22:33:44 2 Gb/sec 2 Gb/sec
8 10:00:80:08:11:22:33:44 2 Gb/sec 2 Gb/sec
9 10:00:80:09:11:22:33:44 2 Gb/sec 2 Gb/sec
10 10:00:80:10:11:22:33:44 1 Gb/sec 2 Gb/sec
11 10:00:80:11:11:22:33:44 1 Gb/sec 2 Gb/sec
12 10:00:80:12:11:22:33:44 1 Gb/sec 2 Gb/sec
13 10:00:80:13:11:22:33:44 1 Gb/sec 2 Gb/sec
14 10:00:80:14:11:22:33:44 1 Gb/sec 2 Gb/sec
15 10:00:80:15:11:22:33:44 1 Gb/sec 2 Gb/sec
show.port.nodes
Syntax nodes portNumber
Purpose This command displays the loginserver entries for a specified port.
This command is valid only on the Sphereon 4300 and Sphereon 4500
switches.
Port The port number.
WWN The WWN of the port.
OpSpeed The current operating speed (1 Gb/sec,
2 Gb/sec, or Not Established).
SpeedCap The current transceiver capability speed
(1 Gb/sec or 2 Gb/sec).