FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-169
show
Output Example The show.port.nodes command output for a mix of public and
private nodes on a loop appears as follows:
FCAddr BB Crdt RxFldSz COS Port Name Node Name
------ ------- ------- --- ----------------------- -----------------------
612902 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
612903 10 2112 2 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
612904 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
612905 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AB 8 2112 2 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AC 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AD 8 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AE 10 3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129FD 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129FE 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
show.port.opticEDD
Syntax OpticEDD
Purpose This command displays optic diagnostic information for all ports.
This information is in HEX format. If there is no information
available, then “Unk” will be displayed for “Unknown”.
Parameters This command has no parameters.
Command Example
Show port opticEDD
Output The port optic diagnostic data is displayed as a table that includes the
following properties.
Port The port number.
Xcvr The transceiver type.
Temp The optic temperature in Celsius.
3.3 Voltage The 3.3 Voltage in Volts.
Current The Current in mA.
TX Pwr The Transceiver power in uW.