FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-171
show
Output Example The show.port.opticInfo command output displays as follows:
Port Xvr Temp 3.3 Volt Current TX Power RX Power 1.8 Volt 5.0 Volt
---- --- ----- -------- ------- --------- --------- -------- -------
0 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
1 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
2 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
3 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
4 XFP 36.105 3.256 5.324 602.100 289.300 1.779 4.998
show.port.profile
Syntax show portNumber
Purpose This command displays the port configuration for a single port
Parameters This command has one parameter.
Command Example
Root> show port profile portNumber 138
Output The port profile information is displayed as a single output for an
individual port.
portNumber Specifies the port number. Valid values
are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Port Number Port number.
Name Configured port name.
Blocked Blocked state. Valid values are true and
false.
Operating Type Operating port type.
Operating Speed Operating port speed.