FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-178
Enterprise Operating System Command Line Interface User Manual
show
show.preferredPath.showPath
Syntax showPath destDomainID sourcePort
Purpose This command displays the specified Preferred Path configuration
and the actual path used by the system. The output shows both the
exit port as configured for the Preferred Path feature and the actual
exit port currently being used for traffic.
Use all for one of the command’s parameters to display all configured
and actual exit ports for either the destination domain ID or the
specified source Port. You cannot specify all for both parameters. If
the destination domain is set to all, all paths from the specified source
port are displayed. If the source port is set to all, the output shows all
source port paths to the specified domain.
Parameters This command has the following parameters.
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31 or all, which
shows all paths to and from the source port
specified in the sourcePort parameter.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or, you can specify all to show all paths to the
destination domain ID specified for the
destDomainId parameter.