FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-179
show
Output The output from show.preferredPath.showPath includes the
following parameters.
Command and
Output Examples
The following examples show the output returned by the three
methods of specifying the show.preferredPath.showPath command.
Single values for both parameters
Root> show preferredPath showPath 21 10
Preferred Path State: Enabled
Preferred Exit Port: Not Configured
Actual Exit Port: 45
destDomainId set to all
Root> show preferredPath showPath all 15
Preferred Path State: Enabled
Destination Domain Preferred Exit Port Actual Exit Port
------------------ ------------------- ----------------
1 23 23
3 24 No Path
4 23 23
17 12 No Source
Destination
Domain
The destination domain ID to which a preferred
path has been configured. This is displayed
only if the destination domain parameter is set
to all.
Source Port The source port for which a preferred path to
the specified destination domain ID is specified.
This is displayed only if the source port
parameter is set to all.
Preferred Exit
Port
The configured Preferred Path exit port. This
value can be any port number, or blank to
indicate that no Preferred Path has been
configured.
Actual Exit Port This is the actual exit port being used for the
given path.