FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-183
show
Port WWN Binding Bound WWN
---- ----------- -----------------------
0 Active AA:00:AA:00:AA:00:AA:00
1 Inactive 00:00:00:00:00:00:00:00
2 Inactive CC:33:44:55:CC:33:44:55
3 Active 00:00:00:00:00:00:00:00
4 Inactive 00:00:00:00:00:00:00:00
5 Inactive 00:00:00:00:00:00:00:00
6 Inactive 00:00:00:00:00:00:00:00
7 Inactive 00:00:00:00:00:00:00:00
8 Inactive 00:00:00:00:00:00:00:00
9 Inactive 00:00:00:00:00:00:00:00
10 Inactive 00:00:00:00:00:00:00:00
11 Inactive 00:00:00:00:00:00:00:00
12 Inactive 00:00:00:00:00:00:00:00
13 Inactive 00:00:00:00:00:00:00:00
14 Inactive 00:00:00:00:00:00:00:00
15 Inactive 00:00:00:00:00:00:00:00
show.security.switchAcl
Syntax switchAcl
Purpose This command displays the contents of the Switch Access Control
List.
Parameters This command has no parameters.
Command Example
Root> show security switchACL
Output The data is displayed as a table that includes the following
properties:
Output Example
ACL State: Disabled
Starting IP Address Ending IP Address
------------------- -----------------
110.80.1.1 110.80.255.255
110.81.1.10 110.81.1.255
200.11.15.1 200.11.255.128
Switch ACL State The enabled state of the Switch Access
Control List
Starting IP
Address
The starting IP Address of a range in the
access control list.
Ending IP
Address
The ending IP Address of a range in the
access control list.