FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-187
show
Switch Priority The switch priority as set in the
config.switch.priority command. For more
information, see config.switch.priority on
page 2-75.
Speed The switch speed as set in the
config.switch.speed command. (This does not
apply to the Sphereon 4300 and Sphereon 4500
switches.) For more information, see
config.switch.speed on page 2-78.
Rerouting Delay The rerouting delay as set in the
config.switch.rerouteDelay command. For more
information, see config.switch.rerouteDelay on
page 2-77.
Interop Mode The interoperability mode as set in the
config.switch.interopMode command. For more
information, see config.switch.interopMode on
page 2-74.
Active Domain
Id
The active domain ID of the switch. This ID
may or may not be the same as the preferred
domain ID.
World Wide
Name
The WWN for the switch.
Insistent Domain
Id
Configured Insistent domain ID state as set in
the config.switch.insistDomainId command.
For more information, see
config.switch.insistDomainId on page 2-73.
Domain RSCN Configured Domain RSCN state as set in the
config.switch.domainRSCN command. For
more information, see config.switch.domainRSCN
on page 2-72.
Zoning RSCN Configured Zoning RSCN state as set in the
config.switch.zoningRSCN command. For more
information, see config.switch.zoningRSCN on
page 2-81.
FC Address
Domain Id
The domain ID of the switch derived from the
Fibre Channel Address.
Limited Fabric
RSCN
When enabled, fabric RSCNs are suppressed
after an IPL.