FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-190
Enterprise Operating System Command Line Interface User Manual
show
Syntax alerts
Purpose This command provides the name, type, and enabled state of each
configured threshold alert, including both counter threshold alerts
(CTAs) and throughput threshold alerts (TTAs).
Parameters This command has no parameters.
Command Example
Root> show thresholdAlerts alerts
Output The threshold alert data displays as a table that includes the
following properties.
Name The name of the threshold alert, truncated to 45
characters.
Type The trigger statistic or threshold type of the alert
(abbreviated to 17 characters). These include:
Tx Util TTA - Transmit Utilization
Rx Util TTA - Receive Utilization
Tx/Rx Util TTA - Transmit or Receive
Utilization
Link Resets Sent CTA - Link Resets Sent
Link Resets Received CTA - Link Resets Received
OLS Sent CTA - OLS Sent
OLS Received CTA - OLS Received
Link Failures CTA - Link Failures
Sync Losses CTA - Sync Losses
Signal Losses CTA - Signal Losses
Protocol Errors CTA - Primitive Sequence
Errors/Protocol Errors
Invalid Tx Words CTA - Invalid Tx Words
CRC Errors CTA - CRC Errors
Discarded Frames CTA - Discarded Frames
Frames Too Short CTA - Frames Too Short