FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

1
Introduction
1-5
Entering Command Line Interface Commands
Command Tree
The command tree of the CLI begins from the root. Table 1-2 shows
the CLI command tree. The commands in the four extended branches
(config, maint, perf, and show) are described in Chapter 2, CLI
Commands.
The following commands are not listed in the command tree, but are
globally available and are documented in this chapter:
• login (see login on page 1-15)
•logout (see logout on page 1-16)
• commaDelim (see Using the commaDelim Command on page 1-17)
Table 1-2 shows the command tree hierarchy from the root, reading
from left to right.
Table 1-2 CLI Command Tree
config---------- enterpriseFabMode--- setState
features ----------------- enterpriseFabMode
ficonMS
installKey
NPIV
openSysMS
openTrunking
show
fencing------------------- addPolicy
addPort
deletePolicy
removePort
setParams
setState
show
showTypeTable
ficonCUPZoning------- addControlHost
deleteControlHost
setState
show
ficonMS------------------ setMIHPTO
setState
show