FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

Table Of Contents
A
A-20
Enterprise Operating System Command Line Interface User Manual
Message Error 139: Insistent Domain ID's Must Be Enabled When Fabric
Binding Active
Description The user attempted to disable insistent domain IDs while fabric
binding was active.
Action Insistent domain IDs must remain enabled while fabric binding is
active. If fabric binding is set to inactive, the insistent domain ID state
may be changed. It should be noted, however, that this can be
disruptive to the fabric.
Message Error 140: Invalid Insistent Domain ID State
Description The request cannot be completed because an invalid insistent domain
ID state has been submitted.
Action The insistent domain ID state must be set to either enable or disable.
For more information, see config.switch.insistDomainId on page 2-73.
Message Error 141: Invalid Enterprise Fabric Mode
Description The request cannot be completed because an invalid enterprise fabric
mode has been submitted.
Action The enterprise fabric mode must be set to either activate or deactivate.
For more information, see config.enterpriseFabMode.setState on
page 2-5.
Message Error 142: Invalid Domain RSCN State
Description The request cannot be completed because an invalid domain RSCN
state has been submitted.
Action The domain RSCN state must be set to either enable or disable. For
more information, see config.switch.domainRSCN on page 2-72.