FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

A
Error Messages
A-35
Message Error 224: Invalid Argument
Description One or more parameters are invalid for this command.
Action Consult this manual (Chapter 2, CLI Commands) for appropriate
parameter names. Parameters must be typed exactly to specification
to be recognized correctly by the CLI.
Message Error 226: Argument Is Too Long
Description One or more parameters are invalid for this command.
Action For the appropriate parameters, see the section of the manual that
corresponds to the attempted command. Parameters must be typed
exactly to specification to be recognized correctly by the CLI.
Message Error 227: Invalid SNMP Community Name
Description The value entered for the SNMP community name is invalid.
Action The community name must not exceed 32 characters in length.
Duplicate community names are allowed, but corresponding write
authorizations must match. Enter an appropriate SNMP community
name and re-submit.
Message Error 228: Invalid Write Authorization Argument
Description The writeAuthorization parameter does not contain a valid value.
Action Parameters must be typed exactly to specification to be recognized
correctly by the CLI. For more information, see
config.snmp.addCommunity on page 2-68.
Message Error 229: Invalid UDP Port Number
Description The udpPortNum parameter does not contain a valid value.
Action Parameters must be typed exactly to specification to be recognized
correctly by the CLI. For more information, see
config.switch.insistDomainId on page 2-73.