FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

A
A-38
Enterprise Operating System Command Line Interface User Manual
Message Error 238: Invalid Feature Key
Description The feature key entered is invalid.
Action Verify that the feature key was entered correctly and re-submit.
Contact your service representative with further difficulties.
Message Error 239: Fabric binding entry not found
Description The user requested to remove a fabric binding entry that is not in the
pending fabric membership list.
Action Verify that the correct entry (both WWN and Domain ID) is being
requested for removal from the list and re-submit the request.
Message Error 240: Duplicate fabric binding member
Description The user requested to add an entry to the fabric binding list that is
already a member of the list.
Action Verify that the correct entry (both WWN and Domain ID) is being
requested for addition to the list and re-submit the request.
Message Error 241: Comma-delimited mode must be active
Description Comma-delimited mode must be active to execute this command
Action Some commands require that comma-delimited mode be active (e.g.
show.nameserverExt). Enable comma-delimited mode and re-issue
the command.
Message Error 244: Not allowed when Enterprise Fabric Mode is Active and
Switch is Online
Description This operation is not allowed while the switch is in Enterprise Fabric
Mode and the switch is Online.
Action Make sure Enterprise Fabric Mode is not enabled and the switch is
offline.