FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

1
Introduction
1-11
Entering Command Line Interface Commands
Note that the commands are shown, with the exception of the zoning
commands, in alphabetical order to make them easier to locate.
Although the commands can be entered in any order, depending on
the results desired, the order shown in Table 1-2, CLI Command Tree,
page 1-5 for the zoning commands is a typical order in which the
zoning commands are entered.
Note that the order in which commands are entered determines the
order in which the show commands display the values. Refer to
Chapter 2, CLI Commands for examples of show commands output.
openTrunking ---------- config
rerouteLog
port ----------------------- config
exit
info
nodes
opticEDD
opticInfo
profile
showPortAddr
status
technology
preferredPath ---------- showPath
security------------------ fabricBinding
log
log
portBinding
switchAcl
switchBinding
snmp
switch
system
thresholdAlerts-------- alerts
log
zoning
Table 1-2 CLI Command Tree (Continued)