FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

Table Of Contents

2-2

Enterprise Operating System Command Line Interface User Manual

Command Overview

Most of the commands in this chapter are listed in alphabetical order

to make them easy to locate. Although the commands can be entered

in any order, depending on the results desired (so long as the tree

structure is followed), the order used herein for the zoning

commands follows a typical order of entry. The various show

commands are usually entered at the end of a group of other

commands to verify configuration changes.

New and Changed Commands

The following CLI commands are new for this edition of the

Enterprise Operating System Command Line Interface User Manual:

• config.fencing.addPolicy on page 2-10

• config.fencing.addPort on page 2-10

• config.fencing.deletePolicy on page 2-11

• config.fencing.removePort on page 2-12

• config.fencing.setParams on page 2-12

• config.fencing.setState on page 2-14

• config.fencing.show on page 2-14

• config.fencing.showTypeTable on page 2-16

• config.ficonCUPZoning.addControlHost on page 2-16

• config.ficonCUPZoning.deleteControlHost on page 2-17

• config.ficonCUPZoning.setState on page 2-17

• config.ficonCUPZoning.show on page 2-18

• config.ficonMS.setMIHPTO on page 2-18

• config.ficonMS.show on page 2-20

• config.ip.lineSpeed on page 2-21

• config.NPIV.maxPortIDs on page 2-22

• config.NPIV.setState on page 2-23