FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-5
config
• show.port.opticInfo on page 2-170
• show.port.profile on page 2-171
• show.port.showPortAddr on page 2-173
• show.security.log on page 2-181
• show.security.switchAcl on page 2-183
config
The config branch of the CLI command tree contains commands that
set parameter values on the switch or director. These values are not
temporary (session) values, but are retained across power cycles.
The commands in the config branch can only be accessed by a user
with administrator level user rights.
CLI commands are activated on the switch immediately, except as
noted.
In general, the config naming commands (except for the
config.zoning commands) use the USASCII character set. All of the
characters in this 128-character set (the first 7-bit subset of the
ISO-8859-1 Latin-1 character set) are valid. Any exceptions are noted
in the specific command descriptions.
config.enterpriseFabMode.setState
Syntax setState enterpriseFabModeState
Purpose This command sets the Enterprise Fabric Mode state for the fabric.
The SANtegrity™ feature key must be installed to activate the
Enterprise Fabric Mode state.
NOTE: The command config.features.enterpriseFabMode on page 2-6 has
functionality that is identical to this command.
Parameters This command has one parameter.
enterpriseFabModeState Specifies whether enterpriseFabMode is
active. Valid values are activate and
deactivate. Boolean 1 and 0 may be
substituted as values.