FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-6
Enterprise Operating System Command Line Interface User Manual
config
Command Example Root> config enterpriseFabMode setState 1
NOTE: You cannot activate Enterprise Fabric Mode while Open Trunking is
enabled.
config.features.enterpriseFabMode
Syntax enterpriseFabMode enterpriseFabModeState
Purpose This command sets the Enterprise Fabric Mode state for the fabric.
The SANtegrity™ feature key must be installed to activate the
Enterprise Fabric Mode state.
Parameters This command has one parameter.
Command Example
Root> config features enterpriseFabMode 1
NOTE: The command config.enterpriseFabMode.setState on page 2-5 has
functionality that is identical to this command.
config.features.ficonMS
Syntax ficonMS ficonMSState
Purpose This command sets the enabled state of the FICON Management
Server. The FICON Management Server feature key must be installed
in order to enable the FICON Management Server State. (The
Sphereon 4300 and Sphereon 4500 switches do not accept this
command.)
NOTE: This command is displayed on a Sphereon 3016 and 3216 only if
the feature key is installed.
enterpriseFabModeState Specifies whether enterpriseFabMode is
active. Valid values are activate and
deactivate. Boolean 1 and 0 may be
substituted as values.