FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-8
Enterprise Operating System Command Line Interface User Manual
config
config.features.NPIV
Syntax setState NPIVState
Purpose This command sets the enabled state of the NPIV feature. The NPIV
feature key must be installed in order to enable this feature.
Parameters This command has one parameter.
Command Example
Root> config features NPIV enable
NOTE: The command config.NPIV.setState on page 2-23 has functionality that
is identical to this command.
config.features.openSysMS
Syntax openSysMS openSysMSState
Purpose This command sets the enabled state of the Open Systems
Management Server (OSMS). OSMS is a feature that allows host
control and inband management of the director or switch through a
management application that resides on an open-systems
interconnection (OSI) device.
Parameters This command has one parameter.
Command Example
Root> config features openSysMS 1
NOTE: The command config.openSysMS.setState on page 2-24 has
functionality that is identical to this command.
config.features.openTrunking
Syntax openTrunking openTrunkingState
NPIVState Valid values are enable and disable. Boolean 1 and
0 may be substituted as values.
osmsState Specifies whether the Open Systems
Management Server is enabled. Valid values are
enable and disable. Boolean 1 and 0 may be
substituted as values.