FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-9
config
Purpose This command sets the enabled state of the OpenTrunking feature.
The OpenTrunking feature key must be installed in order to enable
open trunking.
Parameters This command has one parameter.
Command Example
Root> config features openTrunking 1
NOTE: The command perf.openTrunking.setState on page 2-107 has
functionality that is identical to this command.
config.features.show
Syntax show
Purpose This command shows the product feature information configured for
this switch.
Parameters This command has no parameters.
Command Example
Root> config features show
Output The product feature data is displayed as a table that includes the
following properties.
openTrunkingState This parameter can be set to enable or disable
the OpenTrunking feature. Boolean 1 and 0
may be substituted as values.
Installed Feature
Set
The feature set installed using a feature key.
Only installed keys are displayed.
Feature Individual features within each set. In many
cases, there is only one feature within each
feature set.
State The state of the individual feature. Fabric-wide
features are displayed as Active/Inactive.
Features related to the switch are displayed as
Enabled/Disabled.