FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-11
config
Parameters This command has two parameters.
NOTE: A range of ports is not accepted as a valid input to this command
(e.g., “0-29” is not acceptable).
The port values can also be substituted with one of the following
keywords that will remove all the ports from the alert, and then use a
specific type of port instead of individual port numbers.
Valid values are:
• eport - This will add all active E ports
NOTE: A fencing policy is not allowed to contain both port types and
individual ports.
Command Example Root> config fencing addPort 24
Root> config fencing addPort eport
config.fencing.deletePolicy
Syntax deletePolicy name
Purpose This command deletes a specified fencing policy. Only disabled
fencing policies can be deleted.
name The name of the fencing policy.
portNumber The new port number to add to the
fencing policy, or all, which will add all of
the individual ports to the fencing policy.
Valid values for the port number are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140