FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-15
config
Parameters This command has one optional parameter.
When no parameters are specified, the command will display the
name, type, and state of all policies. If you use the optional
parameter, it will display all the information about the policy.
NOTE: When the name parameter isn't supplied, then only 50 characters of
the names of the policies will be displayed. You will have to enable Comma
Delimited Mode to view the full name.
Command Example Root> config fencing show
Root> config fencing show Policy_1
Output If you do not specify the name parameter, then the output shows the
following information.
Output Example The output from the config.fencing.show command displays as
follows:
Name Type State
------------------------------ ------------------ -----
Default Protocol Error Policy Protocol Error Disabled
Policy_1 Protocol Error Disabled
name The name of the fencing policy.
Name The name of the policy. This will be
concatenated to 50 characters in the
summary display. The policy full name
will be shown in comma delim mode.
Ports The ports to which the fencing policy will
be applied
Type The type of the fencing policy.
Limit The number of offenses that are allowed
before a port is disabled.
Period The amount of time that limit of number
of offenses must exceed before a port is
fenced.
State The enabled state of the fencing policy.