FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-17
config
Command Example Root> config ficonCUPZoning addControlHost 01:02:03:04:
05:06:07:08
config.ficonCUPZoning.deleteControlHost
Syntax deleteControlHost hostNodeWwn
Purpose This command removes one or all control hosts from the Control
Host List used to determine the FICON host(s) capable of viewing all
ports. This list overrides the FCZ port visibility mask.
Parameters This command has one parameter:
Command Example
Root> config ficonCUPZoning deleteControlHost all
config.ficonCUPZoning.setState
Syntax setState ficonCUPZoningState
Purpose This command sets the enabled state of FICON CUP Zoning. The
FICON Management Server feature key must be installed in order to
enable the FICON CUP Zoning State. (The Sphereon 4300 and
Sphereon 4500 switches do not accept this command.)
NOTE: If the FICON Management Server is enabled, the default
management style is the FICON Management Style. The Open Systems
Management Style cannot be used.
Parameters This command has one parameter.
hostNodeWwn The node WWN of the desired control
host, entered in colon-delimited notation
(e.g., 01:02:03:04:05:06:07:08). You can also
enter all to remove the entire list, if no
attached hosts have supervisory
privileges.
ficonCUPZoningState Specifies whether the FICON Management
Server is enabled. Valid values are enable
and disable. Boolean 1 and 0 may be
substituted as values.