FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-22
Enterprise Operating System Command Line Interface User Manual
config
Output The LAN configuration data is displayed as a table that includes the
following properties.
Output Example The output from the config.ip.show command displays as follows.
IP Address: 10.0.0.0
Gateway Address: 0.0.0.0
Subnet Mask: 255.0.0.0
config.NPIV.maxPortIDs
Syntax maxPortIDs portNumber maxIDs
Purpose This command configures the maximum number of NPIV logins that
are allowed on the specified port.
Parameters This command has two parameters.
Command Example Root> config NPIV maxPortIDs 128
Root> config NPIV portNumber 60
IP Address The IP address.
Gateway
Address
The gateway address.
Subnet Mask The subnet mask.
portNumber Specifies the port number. Valid values
are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
all - applies the maxIDs parameter value
to every port on the product
maxIDs Specifies the maximum number of NPIV
logins allowed on the specified port.Valid
values are in the range 1-256.