FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-24
Enterprise Operating System Command Line Interface User Manual
config
6 130
...
NOTE: The command show.NPIV.config on page 2-159 has functionality that
is the same as this command.
config.openSysMS.setHostCtrlState
Syntax setHostCtrlState HostContrlState
Purpose This command sets the enabled state of the Open Systems
Management Server Host Control.
Parameters This command has one parameter:
Command Example
Root> config openSysMS setHostCtrlState enable
config.openSysMS.setState
Syntax setState osmsState
Purpose This command sets the enabled state of the Open Systems
Management Server (OSMS). OSMS is a feature that allows host
control and inband management of the director or switch through a
management application that resides on an open-systems
interconnection (OSI) device.
Parameters This command has one parameter.
Command Example
Root> config openSysMS setState 1
HostContrlState This parameter can be set to enable or
disable. Boolean 1 and 0 values may also
be substituted.
osmsState Specifies whether the Open Systems
Management Server is enabled. Valid values are
enable and disable. Boolean 1 and 0 may be
substituted as values.