FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-29
config
Parameters This command has no parameters.
Command Example
Root> config port showPortAddr
Output The port configuration is shown as a table of properties. The
following properties are displayed:
Output Example
Port Original Addr Current Addr SwappedPort Num
---- ------------- ------------ ----------------
04 4
15 5
26 7 3
37 6 2
48 8
59 9
6a a
7b b
8c c
...
config.port.speed
Syntax speed portNumber portSpeed
Purpose This command sets the speed for a port. A port can be configured to
operate at 1 Gb/sec, 2 Gb/sec, or a negotiated speed. The port speed
can be set only to 1 Gb/sec if the switch speed is 1 Gb/sec. An
attempt to set the port speed to 2 Gb/sec or to negotiate in a switch
with a 1 Gb/sec switch speed results in an error message.
If the port speed is set to negotiate, the port and the device to which it
is attached negotiate the data speed setting to either 1 Gb/sec or 2
Gb/sec.
Port The port number
Original Addr The original port address of the port
Current Addr The current port address of the port
Swapped Port Num If the port is swapped with another port,
it will show the port number of the port it
is swapped with.