FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-32
Enterprise Operating System Command Line Interface User Manual
config
Parameters This command has two required parameters.
Command Example Root> config port type 4 fport
config.security
The security command on the configuration branch enters the
security configuration branch. All commands under this branch
operate on a particular security attribute.
Some security configuration commands (namely those under the
fabricBinding branch) are different from other CLI commands in that
they are not single action commands that take effect immediately.
These commands implement a rudimentary membership list editor.
A user works on a temporary copy of a membership list in the editor
and can perform actions such as adding or deleting fabric members.
The edited copy can then be activated to the fabric. It should be noted
that not all verification of membership lists can be made in the
pending copy. Therefore, it is possible that a user will build up a
pending membership list definition without errors, but will
encounter errors when saving to the fabric. It should also be noted
that the state of the pending configuration must be set to 'restrict' in
order to make any changes to the (pending) fabric membership list.
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
portType Specifies the type of the port. Valid values for the
port type are:
eport
fport
gport
fxport (Sphereon 4300 and Sphereon 4500 only)
gxport (Sphereon 4300 and Sphereon 4500 only)