FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-35
config
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one parameter:
Command Example
Root> config security authentication interface eport
outgoing disable
config.security.authentication.interface.eport.sequence
Syntax sequence method1 [method2]
Purpose This command sets the sequence that the E port interface will use to
authenticate. When the preferred method cannot be contacted, the
backup method will be used to authenticate the remote end of the
ISL.
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one required parameter, and one optional
parameter:
enabledState This parameter enables and disables
outgoing CHAP authentication on all
ISLs. Accepted values for this parameter
are enable or disable. Boolean 1 and 0
values may also be substituted.
method1 This sets the preferred method of
authentication. Accepted values are local
or RADIUS.
method2 This optional parameter sets the backup
method of authentication. This backup
method is used when the preferred
method cannot be contacted. Accepted
value is local.