FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-37
config
Parameters This command has one required parameter, and one optional
parameter:
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Command Example Root> config security authentication interface nport
sequence RADIUS local
config.security.authentication.interface.osms.outgoing
Syntax outgoing enabledState
Purpose This command determines if outgoing authentication is used on all
OSMS requests. The OSMS key must be configured prior to setting
the outgoing state to enabled.
NOTE: The SANtegrity Authentication feature key must be installed to
configure the OSMS outgoing state.
Parameters This command has one parameter:
Command Example
Root> config security authentication interface osms
outgoing 1
method1 This sets the preferred method of
authentication. Accepted values are local
or RADIUS.
method2 This optional parameter sets the backup
method of authentication. This backup
method is used when the preferred
method cannot be contacted. Accepted
value is local.
enabledState This parameter enables and disables
FCCT authentication. Accepted values
for this parameter are enable or disable.
Boolean 1 and 0 values may also be
substituted.