FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-39
config
Command Example Root> config security authentication serial enhancedAuth
enable
config.security.authentication.interface.show
Syntax show interface
Purpose This command displays the settings in the local authentication
database for a single interface.
NOTE: The SANtegrity Authentication feature key must be installed to view
the eport and nport information, and the OSMS information.
Parameters This command has one parameter.
Command Example
Root> config security authentication interface show Web
Output Example The output for the config.security.authentication.interface.show
command displays as follows:
Interface: Web
Outgoing: N/A
Incoming: N/A
Sequence: Local, RADIUS
config.security.authentication.interface.web.sequence
Syntax sequence method1 [method2]
Purpose This command sets the sequence that the Web interface will use to
authenticate. When the preferred method cannot be contacted, the
backup method will be used to authenticate the Web login.
interface The interface that will be displayed. Valid
values for this parameter are:
cli
web
osms
api
serial
eport
nport.