FW 07.00.00/HAFM SW 08.06.00 McDATA SANpilot User Manual (620-000160-230, April 2005)

3
3-82
McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual
Diagnostics
Did reconfiguring the port type solve the problem?
NO YES
↓ The switch appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
24
One of the following mode-mismatch conditions was detected and an
ISL connection is not allowed:
• The switch is configured for operation in Open Fabric 1.0 mode
and is connected to a fabric element not configured to Open
Fabric 1.0 mode.
• The switch is configured for operation in Open Fabric 1.0 mode
and is connected to a legacy McDATA switch at the incorrect
Exchange Link Parameter (ELP) revision level.
• The switch is configured for operation in Open Fabric 1.0 mode
and is connected to a non-McDATA switch at the incorrect ELP
revision level.
• The switch is configured for operation in McDATA Fabric 1.0
mode and is connected to a non-McDATA switch.
Configure the switch interop mode:
a. Select Fabric Parameters from the Operating Parameters sub
menu. The Configure Fabric Parameters dialog box displays.
Figure 3-37 Configure Fabric Parameters Dialog Box
b. Select McDATA Fabric 1.0 or Open Fabric 1.0 from the Interop
Mode list box.