FW 07.00.00/HAFM SW 08.06.00 McDATA SANpilot User Manual (620-000160-230, April 2005)

MAP 0700: Fabric, ISL, and Segmented Port Problem Determination

3-101

Diagnostics

3. Select (highlight) the zone name to be modified (and later

deleted) at the Zone Library list, then select Copy Zone from

the Actions menu on the dialog box. The Copy Zone dialog

box displays.

4. Type the new zone name (specified by the customer) and

click OK. The new zone name appears in the Zone Library

list. The new zone contains the same members as the copied

zone.

5. Select (highlight) the new zone name and drag (holding the

left mouse button) the name to the Zones in Set list.

6. At the Zones in Set list, select (highlight) the zone name to be

deleted, then drag (holding the left mouse button) the name

off the Modify Zone Set dialog box.

7. At the Modify Zone Set dialog box, click Save Zone Set. The

zone set (with the new zone name) is saved and the dialog

box closes.

8. At the Zone Sets dialog box, select (highlight) the active zone

set name, then select Activate from the Actions menu on the

dialog box. The Activate Zone Set dialog box displays.

9. Click Start. The status message changes to Activate zone

set complete. Click Close to close the dialog box.

10.Click Close to close the Zone Sets dialog box and return to

the Zoning Set tab view with the modified active zone set.

Did the zone name change solve the problem and did both switches

join through the ISL to form a fabric?

NO YES

↓ The switches, associated ISL, and multiswitch fabric appear

operational.

Contact the next level of support.

The switch E_Port segmented because a build fabric protocol error

was detected.

a. Disconnect the fiber-optic jumper cable from the segmented

E_Port.

b. Reconnect the cable to the same port.