HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Last Failure Codes
224 HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
02220100 No buffer found for CACHE$MARK_META_DIRTY call. 01
02270104 A callback from Device Services (DS) on a transfer request has returned
a bad or illegal DWD status:
Last failure parameter [0] contains the DWD Status.
Last failure parameter [1] contains the DWD address.
Last failure parameter [2] contains the Physical Unit Block (PUB) address.
Last failure parameter [3] contains the Device Port.
01
022C0100 A READ_LONG operation was requested for a local buffer transfer.
READ_LONG is not supported for local buffer transfers.
01
022D0101 A WRITE_LONG operation was requested for a local buffer.
WRITE_LONG is not supported for local buffer transfers.
01
02380102 An invalid status was returned from CACHE$LOCK_READ( ):
Last failure parameter [0] contains the DD address.
Last failure parameter [1] contains the invalid status.
01
023A2084 A processor interrupt was generated by the controller FX, indicating an
unrecoverable error condition:
Last failure parameter [0] contains the FX CSR.
Last failure parameter [1] contains the FX direct memory access (DMA)
Indirect List Pointer register (DILP).
Last failure parameter [2] contains the FX DMA Page Address Register
(DADDR).
Last failure parameter [3] contains the FX DMA Command and Control
register (DCMD).
20
02440100 The logical unit mapping type was detected invalid in
VA_SET_DISK_GEOMETRY( ).
01
02530102
02560102
An invalid status was returned from CACHE$LOOKUP_LOCK( ):
Last failure parameter [0] contains the DD address.
Last failure parameter [1] contains the invalid status.
01
Table 56: Last Failure Codes and Repair Action Codes (Sheet 11 of 55)
Last
Failure
Code
Description
Repair
Action
Code