HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Troubleshooting Information
43HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
UPS used for backup power
If a UPS is used for backup power and the controllers are set to
DATACENTER_WIDE, the controllers check the battery and indicate if a battery
failure exists, but they do not take any action (see Figure 5 for an example of the
screen display after issuing the SHOW THIS CLI command):
Figure 5: SHOW THIS CLI sample screen display
Refer to the appropriate installation and configuration guide and controller CLI
reference guide for information about the UPS switches.
HSG> SHOW THIS
Controller:
HSG80 ZG93413884 Software V88.x-0, Hardware E06
NODE_ID = 5000-1FE1-0002-A270
ALLOCATION_CLASS = 0
SCSI_VERSION = SCSI-2
Configured for MULTIBUS_FAILOVER with ZG93513566
In dual-redundant configuration
Device Port SCSI address 6
Time: 29-JUN-2004 13:45:57
Command Console LUN is lun 0 (IDENTIFIER = 300)
Host Connection Table is LOCKED
Smart Error Eject Disabled
.
.
.
Battery:
UPS = DATACENTER_WIDE
FULLY CHARGED
Expires: 18-JUN-2007
Previous controller operation terminated by power failure.