HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

FC Configuration Procedures
141HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide
To disable autospare, use the following command:
SET FAILEDSET NOAUTOSPARE
During initialization, AUTOSPARE checks to see if the new disk drive contains
metadata. Metadata is information the controller writes on the disk drive when the
disk drive is configured into a storageset. Therefore, the presence of metadata
indicates that the disk drive belongs to, or has been used by, a storageset. If the
disk drive contains metadata, initialization stops. (A new disk drive does not
contain metadata but a repaired or reused disk drive might. To erase metadata
from a disk drive, add it to the controller's list of devices, then set it to be
nontransportable and initialize it.)
Deleting a Storageset
Note: If the storageset you are deleting is partitioned, you must delete each
partitioned unit before you can delete the storageset.
1. Show the storageset’s configuration:
SHOW STORAGESET-NAME
2. Delete the unit number that uses the storageset. Use the following command:
DELETE UNIT-NUMBER
3. Delete the storageset. Use the following command:
DELETE STORAGESET-NAME
4. Verify the configuration:
SHOW STORAGESET-NAME
Changing Switches for a Storageset or Device
You can optimize a storageset or device at any time by changing the switches that
are associated with it. Remember to update the storageset profile when changing
its switches.
Displaying the Current Switches
To display the current switches for a storageset or single-disk unit, enter a SHOW
command, specifying the FULL switch:
SHOW STORAGESET-NAME