HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

Backing Up, Cloning, and Moving Data
158 HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide
Figure 42: Clone utility steps for duplicating unit members
To Clone a single-disk unit, stripeset, or mirrorset:
1. Establish a connection to the controller that accesses the unit you want to
Clone.
2. Start Clone using the following command:
RUN CLONE
3. When prompted, enter the unit number of the unit you want to Clone.
4. When prompted, enter a unit number for the Clone unit that Clone creates.
5. When prompted, indicate how you would like the Clone unit to be brought
online: either automatically or only after your approval.
6. When prompted, enter the disk drives you want to use for the Clone units.
7. Back up the Clone unit.
Unit
Disk10300
Unit
Disk10300
Clone of Disk10300
Clone Unit
Temporary mirrorset
Unit
Disk10300
New member
Unit
Disk10300
New member
Temporary mirrorset
CXO5510A
C
o
p
y