HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

Backing Up, Cloning, and Moving Data
161HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide
Moving Storagesets
You can move a storageset from one subsystem to another without destroying its
data. You also can follow the steps in this section to move a storageset to a new
location within the same subsystem.
Caution: Move only normal storagesets. Do not move storagesets that are
reconstructing or reduced, or data corruption results.
See the release notes for the version of your controller software for information on
which drives can be supported.
Caution: Never initialize any container or this procedure does not protect
data in the storageset.
Use the following procedure to move a storageset, while maintaining the data the
storageset contains:
1. Show the details for the storageset you want to move. Use the following
command:
SHOW STORAGESET-NAME
2. Label each member with its name and PTL location.
If you do not have a storageset map for your subsystem, you can enter the
LOCATE command for each member to find its PTL location. Use the following
command:
LOCATE DISK-NAME
To cancel the locate command, enter the following:
LOCATE CANCEL
3. Delete the unit number shown in the “Used by” column of the SHOW
storageset-name
command. Use the following syntax:
DELETE UNIT-NUMBER
4. Delete the storageset shown in the “Name” column of the SHOW storageset-name
command. Use the following syntax:
DELETE STORAGESET-NAME