Compaq StorageWorks UltraSCSI RAID Enclosure (DS-BA370 Series) User's Guide (EK-BA370-UG. C02, September 1998)

Single-Ended I/O Module

UltraSCSI RAID Enclosure 5–17

Table 5–8 Installing Three-Enclosure Subsystem

Cables

1. Complete Table 5–5 to shut down the UltraSCSI subsystem.

2. Use a screwdriver to loosen the two spring-loaded mounting screws

on the I/O module.

3. Grasp the I/O module by

the cable support bracket

and pull it straight

outward until removed

from the enclosure

shroud.

4. Repeat steps 2 and 3 for all the I/O modules within the three

enclosures.

5. On the master enclosure

I/O module, align the

Cable A

ALLOUT

connector with the left

connector. Gently insert

the cable connector into

the module connector.

Tighten both cable

connector thumb screws

to fully seat the

connector.

6. Install a wire tie through the holes on the cable support bracket and

around the cable. Tighten the wire tie.

CXO5816A

CXO5854B