HP StorageWorks HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Release Notes (AA-RV1YA-TE, March 2005)

Hardware and Software Support
34 HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for
Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Release Notes
Note: Transparent failover configurations are not supported for Windows Server 2003
(32-bit).
■ HS_Service records system errors used in conjunction with remote
diagnostics services provided through Proactive Services software.
■ If you see a constantly blinking light on your Fibre Channel Switch, the
topology setting may be set to arbitrated loop mode on your server. To correct
this, remove the existing installation of the Fibre Channel Software and
reinstall the desired setup.
■ When upgrading firmware on the DS-KGPSA-BC HBA from Versions 2.x to
Versions 3.x, follow the procedure in “Reestablishing Host Connections After
Upgrading DS-KGPSA-BC Firmware” on page 44 of these Release Notes.
StorageWorks Command Console (SWCC)
SWCC V2.5 is included in this release and is used to identify the SWCC suite of
components.
SWCC provides a graphical user interface that can be used to configure and
monitor your storage system. Use of SWCC is highly recommended, but not
required. The SWCC Agent is installed as part of the Solution Software Kit.
For more information on SWCC installation, see the HP StorageWorks HSG80
ACS Solution Software Installation and Configuration Guide. For more
information on SWCC Client operation, see the Command Console Version 2.5
User Guide and the Command Console Version 2.5 Release Notes.
SWCC Scalability
■ The SWCC Client can monitor up to 128 host systems, each with up to 32
storage systems, for a maximum of 4096 concurrent storage connections and a
total of 2.65 PB of storage.
■ One Agent can support up to 32 Clients.