HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Maintenance and Service Guide (EK-G80MS-SA. C01, March 2005)

Common Replacement Information and Procedures
73HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Maintenance and Service Guide
■ If the controller is operational, connect a PC or terminal to the controller
maintenance port.
■ If the controller is not operational, Go to step 6 on page 74.
2. From the host console, stop all host activity to the controller, and then
dismount the logical units in the subsystem.
3. If using a Microsoft
® Windows 2000® or Windows NT® platform, shut down
the server.
4. Run the Fault Management Utility (FMU) to obtain the last failure codes, if
desired.
5. Shut down “this controller” with the following command:
SHUTDOWN THIS_CONTROLLER
Note: After the controller shuts down, the Reset button and the first three port LEDs
turn on (see Figure 27). This can take several minutes depending on the amount of
data that needs to be flushed from the cache module.
Figure 27: Controller Reset button and first three port LEDs
Note: For StorageWorks Model 2100 and 2200 enclosures, omit step 6 and step 7
on page 74. The ECB does not contain switches or use ECB Y-cables.
1 Reset button 2 First three port LEDs
123456
CXO6991A
1
2