HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

Preparing the Host System
106 HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
Installing RAID Array Storage System
WARNING: A shock hazard exists at the backplane when the controller
enclosure bays or cache module bays are empty.
Be sure the enclosures are empty, then mount the enclosures into the rack. DO
NOT use the disk enclosure handles to lift the enclosure. The handles cannot
support the weight of the enclosure. Only use these handles to position the
enclosure in the mounting brackets.
Use two people to lift, align, and install any enclosure into a rack. Failure to
use two people might cause personal injury and/or equipment damage.
Caution: Controller and disk enclosures have no power switches. Make sure
the controller enclosures and disk enclosures are physically configured before
turning the PDU on and connecting the power cords. Failure to do so can
cause equipment damage.
1. Be sure the enclosures are empty before mounting them into the rack. If
necessary, remove the following elements from the controller enclosure:
— Environmental Monitoring Unit (EMU)
— Power Supplies
— External Cache Batteries (ECBs)
—Fans
2. If necessary, remove the following elements from the disk enclosure:
— Power Supply/Blower Assemblies
—Disk Drives
— Environmental Monitoring Unit (EMU)
— I/O Modules
3. Refer to the HP StorageWorks Model 2100 and 2200 Ultra SCSI Controller
Enclosures User Guide and the HP StorageWorks Model 4300 Family Ultra3
LVD Disk Enclosures User Guide for further information.
4. Install brackets onto the controller enclosure and disk enclosures. Using two
people, mount the enclosures into the rack. Refer to the mounting kit
documentation for further information.