HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

Installing and Configuring HSG Agent
129HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
Installation and Configuration Overview
Table 13 provides an overview of the installation.
Table 13: Installation and configuration overview
Step Procedure
1 Verify that your hardware has been set up correctly. See the previous
chapters in this guide.
2 Verify that you have a network connection for the Client and Agent systems.
See "About the Network Connection for the Agent", page 130.
3 Verify that there is a LUN for communications. This can be either the CCL or
a LUN that was created with the CLI. See "What is the Command Console
LUN?", page 41, in Chapter 1.
4 Install the Agent (TCP/IP network connections) on a system connected to the
HSG80 controller.
5 Add the name of the Client system to the Agent’s list of Client system entries
(TCP/IP network connections). This can be done during installation or when
reconfiguring the Agent.
6 Install the Client software on Windows 2000 with Service Pack 4 or
Windows NT 4.0 with Service Pack 6A, and Windows Server 2003
(32-bit). See Appendix B.
7 Add the name of the Agent system to the Navigation Tree of each Client
system that is on the Agent’s list of Client system entries (TCP/IP network
connections). See Appendix B.
8 Set up pager notification (TCP/IP network connections). Refer to “Setting Up
Pager Notification” in the
HP StorageWorks Command Console V2.5 User
Guide.